Warning

DMARC isn't strict enough for BIMI

The short version

Set DMARC to quarantine or reject for all mail (pct=100, no t=y) before inboxes show your logo.

What it means

You publish a BIMI record, but your DMARC policy doesn't enforce for all your mail. The detail says why: the policy is none, pct is below 100, the record is in testing mode (t=y), or there is no DMARC record.

Why it matters

Mailbox providers show a BIMI logo only when they are sure the message really comes from you, which means DMARC must tell them to quarantine or reject everything that fails. Until then your logo stays hidden, however good the logo and certificate are. The same rule decides whether a soft SPF ending is a warning in the email grade.

How to fix it

  1. Read your DMARC reports and confirm that all your real mail passes SPF or DKIM in alignment.
  2. Change your DMARC record to p=quarantine (or p=reject). Remove pct= or set it to 100, and remove t=y.
  3. If subdomains send mail, check sp= too.
  4. The DMARC builder can write the new record for you.

Check it worked

Run the MTA-STS checker on your domain again once the old record's TTL has passed, usually within an hour. The BIMI section should show DMARC as enforced for all mail and the verdict as ready.