Fail

Your DMARC record has a syntax error

The short version

Fix the record; the detail shows the part receivers can't read.

What it means

Your DMARC record can't be read as written. Common causes are a record that doesn't start with v=DMARC1, a missing p= tag, a policy word other than none, quarantine or reject, a report address without mailto:, or a percentage above 100. The finding's detail names the part that failed.

Why it matters

Receivers that can't read the record ignore it, so none of its policy applies and no reports arrive. A record that is close to right can look fine in your DNS host's panel while doing nothing at all.

How to fix it

  1. Read the finding's detail to find the broken part.
  2. Make sure the record starts with v=DMARC1; followed by p=none, p=quarantine or p=reject.
  3. Write report addresses as mailto: links, separated by commas.
  4. Rebuild the record in the DMARC builder if in doubt; it always writes valid syntax.
  5. Replace the TXT record at _dmarc with the corrected value.

Cloudflare

Open the domain, go to DNS then Records, and add or edit a TXT record with the name _dmarc. Cloudflare's own DMARC management page can write the record too.

Other DNS hosts

Add a TXT record whose name (host) is _dmarc. Some hosts want the full name, _dmarc.example.com; others add your domain for you, so type only _dmarc.

Check it worked

Run the DMARC checker or the full email check. DMARC records are read fresh once the old record's TTL has passed, usually within an hour. The DMARC section should show the new policy and the finding should be gone.